Oke-Ogun Polytechnic Cut Off Point – 2020/2021

33 0

This article contains information on Oke-Ogun Polytechnic, Shaki, TOPS Cut Off Points. It describes the Polytechnic Cut off Points of various courses for the academic year.

The Office of the Registrar, Oke-Ogun Polytechnic, Shaki, TOPS has released the Cut Off Points for Admissions into a various degree programme for the academic year.

There are certain criteria to be observed before being admitted to study in any of the courses at Oke-Ogun Polytechnic, Shaki, TOPS. One of these which include meeting the required cut-off points for each school as well as the courses itself. It is very easy to obtain admission if one has met the required cut off mark for the admission into a particular course.

The following is Oke-Ogun Polytechnic, Shaki, TOPS to consider before applying for admission to any academic programme available at the institution for the Academic Year.

OKE-OGUN POLYTECHNIC, SHAKI, TOPS CUT-OFF POINTS

The authority of  Oke-Ogun Polytechnic, Shaki, TOPS every academic session releases the admission requirements and the cutoff points needed for admission into its prestigious Polytechnic. The cutoff points are stated below:

The Oke-Ogun Polytechnic, Shaki, TOPS cut off points for admission into any desired course is dependent on the cut off mark provided by the Joint Admission Matriculation Board (JAMB).
The JAMB cutoff mark set for entry into any program at Oke-Ogun Polytechnic, Shaki, TOPS is 120 and above.

You can also check out  admission requirements to get the specific requirement of the course of interest and how to apply.

Further Readings:
  • Oke-Ogun Polytechnic, Shaki, TOPS Full & Fees – 2020
  • Oke-Ogun Polytechnic, Shaki, TOPS Term and Registration Date
Don’t miss out on current updates, kindly & follow us on Follow @Eafinder OR


Leonel Schuster
Leonel Schuster

Kathryn has been Teacher at Alliant International University since 2013. He began to write about admission details at Course Discovery.

Leave a Reply

Your email address will not be published. Required fields are marked *